光碟刻录问题，折腾了一下午都没搞定，紧急求助

etheldreda

先是使用nautilus的自带刻录功能失败，刻录机显示不出来
安装gnomebaker，光驱响了一下就把光盘弹出来了，在详细信息里显示如下：
Executing 'builtin_dd if=/data/disk01/Downloads/azureus/OSX_1048_AMD_SSE3.iso of=/dev/hdc obs=32k seek=0'
/dev/hdc: "Current Write Speed" is 4.1x1352KBps.
:-[ WRITE@LBA=0h failed with SK=4h/ASC=08h/ACQ=03h]: Input/output error
:-( write failed: Input/output error
进入root也没用
又参考了gentoo wiki的指南，采用命令模式：
cdrecord dev=ATA:1,0,0 OSX_1048_AMD_SSE3.iso
结果显示信息如下：
cdrecord: No write mode specified.
cdrecord: Asuming -sao mode.
cdrecord: If your drive does not accept -sao, try -tao.
cdrecord: Future versions of cdrecord may have different drive dependent defaults.
Cdrecord-ProDVD-Clone 2.01.01a20 (i686-pc-linux-gnu) Copyright (C) 1995-2006 Jörg Schilling
scsidev: 'ATA:1,0,0'
devname: 'ATA'
scsibus: 1 target: 0 lun: 0
Warning: Using badly designed ATAPI via /dev/hd* interface.
Linux sg driver version: 3.5.27
Using libscg version 'schily-0.8'.
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'PIONEER '
Identifikation : 'DVD-RW  DVR-109 '
Revision       : '1.50'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
resid: 32
Using generic SCSI-3/mmc-2 DVD-R/DVD-RW/DVD-RAM driver (mmc_dvd).
Driver flags   : DVD MMC-3 SWABAUDIO BURNFREE
Supported modes: PACKET SAO
resid: 32
Starting to write CD/DVD at speed 4 in real SAO mode for single session.
Last chance to quit, starting real write    0 seconds. Operation starts.
Turning BURN-Free off
cdrecord: Success. reserve_track_rzone: scsi sendcmd: no error
CDB:  53 00 00 00 00 00 1E 78 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0E 00 00 00 00 64 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x64 Qual 0x00 (illegal mode for this track) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.005s timeout 100s
cdrecord: Cannot open next track.

硬件方面是绝对没有问题的，不知道为什么搞不定，真是郁闷到极点，真不明白设计人员是怎么想的，难道不能替用户提供一个默认就可以使用的方式吗

7dehao

#cdrecord dev=ATAPI -scanbus 扫描刻录机设备，记下dev结果，如dev=ATAPI:0,1,0
以40速刻录xx.iso文件：
#cdrecord dev=ATAPI:0,1,0 -v speed=40 -data /tmp/xx.iso

blackwhite

让DVD刻录机工作于DMA模式。
好像cdrecord本身是不支持DVD的，需要patch。
安装dvd+rw-tools，用growisofs刻录。

chezz99

在linux下刻录这么复杂哦!!!!

zhllg

一条命令而已