2.6.13内核起动时还有点错误，请兄弟们帮忙看一下。

3331

pd: pd version 1.05, major 45, cluster 64, nice 0
pda: Autoprobe failed
pd: no valid drive found
sb: Init: Starting Probe...
sb: Error: At least io, irq, and dma must be set for legacy cards.
sb: Init: Done


pda,pd,sb检测什么硬件的？

内核配置要怎么改啊？

完整的dmesg如下：
Linux version 2.6.13-gentoo-r3 (root@Gentoo) (gcc version 3.3.5-20050130 (Gentoo 3.3.5.20050130-r1, ssp-3.3.5.20050130-1, pie-8.7.7.1)) #9 Sun Nov 6 23:29:51 CST 2005
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000e8000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000000eff0000 (usable)
BIOS-e820: 000000000eff0000 - 000000000eff8000 (ACPI data)
BIOS-e820: 000000000eff8000 - 000000000f000000 (ACPI NVS)
BIOS-e820: 00000000ffef0000 - 00000000fff00000 (reserved)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
239MB LOWMEM available.
On node 0 totalpages: 61424
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 57328 pages, LIFO batch:31
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.3 present.
Allocating PCI resources starting at 0f000000 (gap: 0f000000:f0ef0000)
Built 1 zonelists
Kernel command line: root=/dev/hda1
Initializing CPU#0
PID hash table entries: 1024 (order: 10, 16384 bytes)
Detected 731.124 MHz processor.
Using tsc for high-res timesource
Console: colour VGA+ 80x25
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 239876k/245696k available (1860k kernel code, 5312k reserved, 779k data, 116k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 1463.76 BogoMIPS (lpj=2927533)
Mount-cache hash table entries: 512
CPU: After generic identify, caps: 00803035 80803035 00000000 00000000 00000000 00000000 00000000
CPU: L1 I Cache: 64K (32 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 64K (32 bytes/line)
CPU: After all inits, caps: 00803135 80803035 00000000 00000000 00000000 00000000 00000000
CPU: Centaur VIA Samuel 2 stepping 02
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfdb11, last bus=1
PCI: Using configuration type 1
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Uncovering SIS18 that hid as a SIS503 (compatible=0)
Enabling SiS 96x SMBus.
Boot video device is 0000:01:00.0
PCI: Using IRQ router SIS [1039/0018] at 0000:00:01.0
PCI: Ignore bogus resource 6 [0:0] of 0000:01:00.0
PCI: Bridge: 0000:00:02.0
  IO window: a000-afff
  MEM window: dfe00000-dfefffff
  PREFETCH window: cfc00000-dfcfffff
PCI: Setting latency timer of device 0000:00:02.0 to 64
Real Time Clock Driver v1.12
Linux agpgart interface v0.101 (c) Dave Jones
agpgart: Detected SiS 630 chipset
agpgart: AGP aperture is 64M @ 0xe0000000
[drm] Initialized drm 1.0.0 20040925
[drm] Initialized sis 1.1.0 20030826 on minor 0:
i8042.c: Detected active multiplexing controller, rev 1.1.
serio: i8042 AUX0 port at 0x60,0x64 irq 12
serio: i8042 AUX1 port at 0x60,0x64 irq 12
serio: i8042 AUX2 port at 0x60,0x64 irq 12
serio: i8042 AUX3 port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
parport0: PC-style at 0x378 [PCSPP(,...)]
mice: PS/2 mouse device common for all mice
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
input: AT Translated Set 2 keyboard on isa0060/serio0
Synaptics Touchpad, model: 1, fw: 5.0, id: 0xf40b1, caps: 0x804713/0x0
input: SynPS/2 Synaptics TouchPad on isa0060/serio4
floppy0: no floppy controllers found
loop: loaded (max 8 devices)
8139too Fast Ethernet driver 0.9.27
PCI: Found IRQ 10 for device 0000:00:05.0
PCI: Sharing IRQ 10 with 0000:00:01.6
eth0: RealTek RTL8139 at 0xcf812000, 00:07:95:a5:26:76, IRQ 10
eth0:  Identified 8139 chip type 'RTL-8100'
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SIS5513: IDE controller at PCI slot 0000:00:00.1
SIS5513: chipset revision 208
SIS5513: not 100% native mode: will probe irqs later
SIS5513: SiS630 ATA 100 (1st gen) controller
    ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hdaMA, hdbMA
    ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdcMA, hddMA
Probing IDE interface ide0...
hda: ST9402113A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
hdc: SR243T, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 1024KiB
hda: 78140160 sectors (40007 MB) w/2048KiB Cache, CHS=16383/255/63
hda: cache flushes supported
hda: hda1 hda2 hda3 hda4 < hda5 >
hdc: ATAPI 24X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.20
pd: pd version 1.05, major 45, cluster 64, nice 0
pda: Autoprobe failed
pd: no valid drive found
sb: Init: Starting Probe...
sb: Error: At least io, irq, and dma must be set for legacy cards.
sb: Init: Done
Trident 4DWave/SiS 7018/ALi 5451,Tvia CyberPro 5050 PCI Audio, version 0.14.10j-2.6, 23:08:24 Nov  6 2005
PCI: Found IRQ 11 for device 0000:00:01.4
trident: SiS 7018 PCI Audio found at IO 0xd400, IRQ 11
ac97_codec: AC97 Audio codec, id: ALG16 (ALC200/200P)
ac97_codec: AC97 Modem codec, id: SIL33 (Unknown)
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
ReiserFS: hda1: found reiserfs format "3.6" with standard journal
ReiserFS: hda1: using ordered data mode
ReiserFS: hda1: journal params: device hda1, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30
ReiserFS: hda1: checking transaction log (hda1)
ReiserFS: hda1: Using r5 hash to sort names
VFS: Mounted root (reiserfs filesystem) readonly.
Freeing unused kernel memory: 116k freed
Adding 257032k swap on /dev/hda2.  Priority:-1 extents:1
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
PCI: Found IRQ 5 for device 0000:00:01.2
PCI: Sharing IRQ 5 with 0000:00:01.3
ohci_hcd 0000:00:01.2: OHCI Host Controller
ohci_hcd 0000:00:01.2: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:01.2: irq 5, io mem 0xdffd0000
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
PCI: Found IRQ 5 for device 0000:00:01.3
PCI: Sharing IRQ 5 with 0000:00:01.2
ohci_hcd 0000:00:01.3: OHCI Host Controller
ohci_hcd 0000:00:01.3: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:01.3: irq 5, io mem 0xdffe0000
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 3 ports detected
usb 1-1: new low speed USB device using ohci_hcd and address 2
usbcore: registered new driver hiddev
input: USB HID v1.10 Mouse [USB Mouse] on usb-0000:00:01.2-1
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.01:USB HID core driver
USB Universal Host Controller Interface driver v2.3
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1