Ubuntu 6.10 install on Fujitsu PrimePower 200 Sparc64 problem

slo

我有一台Fujitsu PrimePower 200的Sparc64机器，安装Ubuntu 6.10 for Sparc或者Getnoo2006.1 for Sparc64的时候都会出现一下问题：

1. 
   
2. Stop-A
   
3. ok boot cdrom
   
4. screen not found.
   
5. Can't open input device.
   
6. Keyboard not present.  Using ttya for input and output.
   
7. 
   
8. 
   
9. 
   
10. Fujitsu PRIMEPOWER 200 1x SPARC64 IV 602MHz, No Keyboard
    
11. OpenBoot 3.11 J , 2048 MB memory installed, Serial #15891257.
    
12. Ethernet address 0:80:17:84:7b:39, Host ID: 80f27b39.
    
13. SCF Version: 3.3.F , RCI Version: 0001
    
14. 
    
15. 
    
16. 
    
17. Rebooting with command: boot cdrom
    
18. Boot device: /pci@17,4000/scsi@3/disk@4,0:f  File and args:
    
19. SILO Version 1.4.12
    
20. \
    
21. 
    
22. 
    
23.                        Welcome to Ubuntu edgy!
    
24. 
    
25. This is an Ubuntu installation CDROM, built on 20061025.1.
    
26. Keep it once you have installed your system, as you can boot from it
    
27. to repair the system on your hard disk if that ever becomes necessary.
    
28. 
    
29. WARNING: You should completely back up all of your hard disks before
    
30.   proceeding. The installation procedure can completely and irreversibly
    
31.   erase them! If you haven't made backups yet, remove the rescue CD from
    
32.   the drive and press L1-A to get back to the OpenBoot prompt.
    
33. 
    
34. Ubuntu comes with ABSOLUTELY NO WARRANTY, to the extent permitted by
    
35. applicable law.
    
36. 
    
37. [ ENTER - Boot install ]   [ Type "rescue" - Boot into rescue mode ]
    
38. boot:
    
39. Allocated 8 Megs of memory at 0x40000000 for kernel
    
40. Loaded kernel version 2.6.17
    
41. Loading initial ramdisk (5260517 bytes at 0x100000000 phys, 0x40C00000 virt)...
    
42. Illegal Instruction
    
43. %TL:1 %TT:10 %TPC:404434 %TnPC:404438 %TSTATE:4400001600
    
44. %PSTATE:16 ( IE:1 PRIV:1 PEF:1 )
    
45. ok
    

复制代码

哪位能指点一下？:ask