各位还要问下:(

eackl

1) Kernel sources must be installed and configured. Usually this means
installing the 'kernel-source', 'make' and 'gcc' packages with YaST2.
Update it - if not already done - via YaST2 Online Update (YOU).

2) Use the nvidia installer for 1.0-8178.

sh NVIDIA-Linux-x86-1.0-8178-pkg1.run -q

3) Configure X.Org with

sax2 -m 0=nvidia (0 is a digit, not a letter!)

NOTE: There is no need to try to enable 3D support. It's already
enabled, when the nvidia driver is running.

搞不明白 能帮翻译或详细说下吗？ e文太烂。

charliechan

Post by eackl
1) Kernel sources must be installed and configured. Usually this means
installing the 'kernel-source', 'make' and 'gcc' packages with YaST2.
Update it - if not already done - via YaST2 Online Update (YOU).

2) Use the nvidia installer for 1.0-8178.

sh NVIDIA-Linux-x86-1.0-8178-pkg1.run -q

3) Configure X.Org with

sax2 -m 0=nvidia (0 is a digit, not a letter!)

NOTE: There is no need to try to enable 3D support. It's already
enabled, when the nvidia driver is running.

搞不明白 能帮翻译或详细说下吗？ e文太烂。

1)內核原碼必需要安裝及設定，通常這個動作能夠通過使用YaST2安裝'kernel-source'、'make'及'gcc'而完成，並記得使用YaST2線上更新更新它們 - 若果你尚未進行更新

2)使用為1.0-8178版本而設計的nvidia安裝程式
sh NVIDIA-Linux-x86-1.0-8178-pkg1.run -q

3)使用以下命令設定X.Org

sax2 -m 0=nvidia (0是數字，不是字母!)

aiker35214

1，让你用YAST2装KERNEL SOURCES，MAKE ,GCC
2，使用NVIDIA驱动1.0－8178版 SH开头的是命令
3，配置X.ORG WITH  SAX2那个是配置项
NOTE是著名，说你现在没必要开启3D支持，因为当你的NVIDIA驱动工作的时候，3D效果早就开了

aiker35214

5555.在我漫长的等待上传回复的时候，竟然被人抢先了，唉

eackl

呵呵 谢谢了。
我在去试试 没装驱动时候跑是 200多。
等装好了在看看